SGI Ethernet Card Guide d'installation télécharger pdf (Page 23)

5. Type cu -l ttyS0 -s 38400 at the Linux prompt. The L1

responds with “Connected” as shown:

$ cu -l ttyS0 -s 38400

Connected.

6. Press the Enter key to display the L1 prompt.

001c04>

Connecting the Workstation to a C-brick L1 Port

To connect a Silicon Graphics 230 visual workstation to the L1 port (USB

port) on the SGI Origin 3200 server C-brick, follow these steps (see

Figure 6):

1. Power off the workstation and the SGI Origin 3200 server.

2. Connect a USB cable from the workstation to the L1 port (USB port)

on the C-brick.

3. Ensure that you are in the /stand/sysco/bin directory.

4. Type the following at the Linux prompt to establish a connection:

$ ./l2

Note: Ensure that the L1 network auto-detect is enabled or ensure

that the C-brick network interface ports are set to 422 protocol.

L3Con_Install.fm Page 23 Tuesday, February 27, 2001 8:01 AM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

SGI Ethernet Card Guide d'installation Page 23