SGI Ethernet Card Guide d'installation télécharger pdf (Page 20)

4. Enter the following command to load the diagnostic software:

# l3_install

5. Remove the SGI Origin 3000 series L3 controller CD-ROM.

6. Reboot the system.

Installing the Software from the Network

To install the L3 controller software from the network, follow these steps:

1. Go to the following website:

http://www.sgi.com/products/evaluation/

2. Scroll down the page and click on Origin 3000 Series L3 Controller

1.2.

Note: The release number may vary as new releases of the software

are released.

3. Follow the website instructions until you have completed the

installation.

L3Con_Install.fm Page 20 Tuesday, February 27, 2001 8:01 AM

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

SGI Ethernet Card Guide d'installation Page 20