SGI UV 2000 Guide de l'utilisateur Page 34

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 110
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 33
16 007-5832-001
1: Operation Procedures
The system will take time to fully power up (depending on size and options).
Specific CLI Commands Used With the SMN
The following list of available CLI commands are specifically for the SMN:
auth authenticate SSN/APPWT change
bios perform bios actions
bmc access BMC shell
cmc access CMC shell
config show system configuration
console access system consoles
help list available commands
hel access hardware error logs
hwcfg access hardware configuration variable
leds display system LED values
log display system controller logs
power access power control/status
Type '<cmd> --help' for help on individual commands.
Optional Power On From the CMC Command Line
Because every SGI UV 2000 system comes with a system management node there should be few
reasons for powering on the system from a CMC. Use the following information if you have a need
to power on from a CMC rather than the SMN CLI or the SGI Management Center GUI. If the
SMN is not available you can still boot the system directly by using the CMC, see “Booting
Directly From a CMC”.
Vue de la page 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 109 110

Commentaires sur ces manuels

Pas de commentaire