SGI Octane III Guide de l'utilisateur télécharger pdf (Page 13)

Quick Setup Procedures

007-5633-001 5

System Connections and Power On

Once you have located the system in its operating environment, use the following steps and

illustrations to connect to power, Ethernet, monitor/keyboard/mouse and optional components:

1. Connect the keyboard and mouse to USB connectors on the rear of the enclosure.

2. Connect your monitor to the VGA or optional DVI video connector on the rear panel of the

system. See Table 1-1 on page 9 for more information on video/optional connectors.

3. Plug a Cat-5 or equivalent Ethernet cable to GIGE-0 on the rear panel of the system and

connect it to your local area network (LAN) as applicable.

4. If you have ordered an optional external DVD-RW drive, connect it to one of the remaining

USB plugs on the rear of the system. Power-up the external drive after you have

successfully booted the Octane III.

Figure 1-2 Octane III Rear Panel Connectors

5. With the enable power switch in the off (0) position, connect each of the power cables from

the power supply connectors on the rear of the system to approved wall plug outlets near the

work area. Note that the enable power switch is located between the two power plugs.

6. Push the enable power switch to the on (1) position to start the system, see Figure 1-3 on

page 6.

Caution: The power suppply cords are used as the main disconnect device, ensure that the

sockets/outlets are located or installed near the equipment and are easily accessible.

USB-0

USB-2

USB-1

USB-3

VGA SERIAL

DVI-0 DVI-1

GIGE-0

GIGE-1

GIGE-2 GIGE-3

Enable

ower switch

USB ports DVI ports

VGA

port

Serial

port

Ethernet

ports

SW-CONSOLE

Console

port

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Pas de commentaire

SGI Octane III Guide de l'utilisateur Page 13